NAME PLATE > ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    HINT:
    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    NOTICE:
    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    HINT:
    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.


Text in Illustration 
*1
NO. 1 BACK DOOR NAME PLATE
*2
NO. 2 BACK DOOR NAME PLATE
*3
BODY SIDE NAME PLATE
*4
NO. 2 FRONT FENDER NAME PLATE
*5
NO. 1 FRONT FENDER NAME PLATE
*6
Profile of Back Fender Panel
*7
Profile of Back Fender Panel
*8
Profile of Front Fender Panel
*9
Profile of Front Fender Panel
*10
Profile of Rear Door Panel

Reference Value 
Area
Measurement
Area
Measurement
*a
30.7 mm (1.21 in.)
*b
66.9 mm (2.63 in.)
*c
131.1 mm (5.16 in.)
*d
29.7 mm (1.17 in.)
*e
65.0 mm (2.56 in.)
*f
130.6 mm (5.14 in.)
*g
34.2 mm (1.35 in.)
*h
47.7 mm (1.88 in.)
*i
52.6 mm (2.07 in.)
*j
47.2 mm (1.86 in.)
*k
112.1 mm (4.41 in.)
*l
55.8 mm (2.20 in.)
*m
54 mm (2.13 in.)
*n
47.2 mm (1.86 in.)
*o
112.1 mm (4.41 in.)
*p
55.8 mm (2.20 in.)
*q
54 mm (2.13 in.)
-
-

K100869E01


K100870E01


K100886E01